By androkavo Follow
How to Draw a Lamp Step by Step
This tutorial shows how to draw a table lamp with a lamp shade in six steps. It provides simple illustrated examples and quick instructions.
You can see a preview of the drawing steps in the example above. The lamp in this case has a fairly standard look with parts that table lamps tend to have.
Start the tutorial in pencil and make light lines that are easy to erase in case you need to make a correction. You can darken them later on with a black pen or marker.
Step 1 – Draw the Lamp Shade
Begin by drawing the lamp shade. It’s shape should be like that of an upside down bucket with a wider bottom and narrower top. You can draw the top with a slight curve and make the bottom flat.
Step 2 – Draw the Pipe
Going down from the shade draw the pipe with just a pair of short straight lines.
Simple Street Lamp With Paper
By androkavo Follow
Simple street lamp with page & some electronic components
I used for night lamp, also can use decorate your home or anywhere you want
Power by 5v usb cable
Detail all steps, you can watch video
Attachments
Add Tip Ask Question Comment Download
Step 1: The Road
You need A4 paper high thickness with black paint for make ground
(paper high thickness use only for make ground)
Road Lines, make paper pieces with size
apply to ground by double sided tape or glue
– A4 paper high thickness
– A4 paper normal
– Black paint & Paintbrush
– Double sided tape
Add Tip Ask Question Comment Download
This step for make street light, with frame is paper and light by led 1w
single core copper wire is important for stable frame
– single core copper wire (copper diameter 0.6mm)
– 33 ohm Resistor
resistor for limit current and heat of led, also change brightness
1 ohm is best for max brightness
Add Tip Ask Question Comment Download
Next for make traffic light, i use led 3mm (red, green, yellow)
frame still by paper
Materials :
– Led 3mm (red, green, yellow)
– normal copper wire
– 10k Resistor (x2)
Add Tip Ask Question Comment Download
Put street light & traffic light at position you want, make holes on road for wire can through
And use tape, glue make stable position for light and wire
Then solder for group wire (+ -) of street light & traffic light
USB cable cut wire green and white, use only red (+) and black (-)
Solder again for group all wire, don’t forget add other A4 paper for cover and protect wire
Add Tip Ask Question Comment Download
Step 5: Complete & Test
Power with 5V from adapter or USB port of desktop, laptop, powerbank
Add Tip Ask Question Comment Download